'nuff said.
with stock gauges included plzz

 

this is what i have...

rd2 cluster shell and PCB only. also have the stock faces from an rd2.

i dont have any of the little needle motors, but you can just swap your rd1 in the rd2. everything will be fine.

i also dont have any of the rd2 clear peices. however, with some carefull cutting of yours with a hot knife or even dremel, you can fit yours in by sacrificing a few "mount posts"(no other name comes to mind).

everything will work like a stock rd2 cluster after you trim those clear plastic peices.

 

how much?
it's not going to be a lot of work to put in the plastic pieces and the motors is it? just a few screws right?