In my ongoing quest to get my cylinder head rework done on the cheap, I'm at the point of asking if anyone has a set of valves I can buy off 'em, or maybe a whole cylinder head if the price is right (you could keep the cams). Caveat: these must be from an engine that was removed from service when it was still running decent. I need them straight enough to re-use. NO busted-timing-belt valves! owned.gif

A fresh set of valves is like $100 from the dealer, so I'm thinking in the $30 range for a used set.

 

Squeaky wheel gets the oil, I've got both (8 valves and a 1/2 assembled head, no cams, only 8 sets of valves, springs, retainers i.e. half assembled).

PM me your address,.

 

Around where I work, the other half of that expression is: "or it gets replaced."

PM sent.

 

Patreezy fell off the planet . . . another member said they'd look & get back with me . . .

SOMEBODY has to have a spare set of intake valves . . . !

 

I do. But it would be a few days before I could pull them. Is Beta 2 the same?

 

I'd hafta check hyundaitechinfo.com to see if the valves are the same.

Couple days would be the fastest any part of this project got completed to date wink1.gif

 

LOL well let me know. It will give me an excuse to start my head build.

 

if ericy falls through I have 7 beta2 intake valves (one is chipped)

 

haha, I'll run on 3 and a half cylinders then! I'll check in the next day or 2, I don't have the head for it tonight. No pun intended!

 

damn.. i knew i forgot something..
i'l ltry to chekc this out asap this week

btw, beta2 valves won't fit, the stems are much longuer