shimanomtber87

Well I just recieved an e-mail from the parts bin that the clutch tool I ordered over a week ago is out of stock and they had to refund my money. Anybody have one or know of where to get one?

If not, anybody who has put a clutch in before, is there any way to rig one up?

Alex01tib

you can just tighten the pressure plate with the clutch disk being held steady with a friend's hands centered, once the bolts are somewhat tight it wont move, you just have to make sure your friend aligns it in the center, otherwise the input shaft wont go through it

shimanomtber87

^^^ I'll give it a shot. First time changing a clutch. Didn't know if it was semi-easy without the tool or not. Thanks alex

lilo shark

i have two of them, interested?

Jay-M

hey bro,

you should have told me earlier so i could have given you mine and sent with the obd scantool, dang!

yes, you can do without it but you have to be really accurate and careful... it might take a little bit of trial and error to get it lined up

btw, dont you have a parts store that does a tool loaning program or something? you can even try to "rent" it from a shop... it's just a good handy tool to have, it will make it easier, especially your a virgin to this

good luck

shimanomtber87

^^^ I would have told you earlier, but I just heard yesterday that partsbin doesn't have it. I've already tried a bunch of different places around here and nobody has one in stock.




I'll give it a shot this weekend w/o one. If I need one I will pm you.

Thanks guys

lilo shark

sounds good.

rusomen

Yo man where r u gonna do your clutch???cause if you might come in NorthEast philly i'll give you one

shimanomtber87

I'm changing the clutch at home i suppose. (I think I can get into the garage this weekend) Anyway, how close to lawerenceville NJ are you? I have a hockey game there tomorrow night and the team might be going through north philly.

rusomen

like an hour away from lawrenceville