Intake Manifold
#31
Senior Member
Thread Starter
Join Date: Jun 2007
Location: Costa Rica
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Just to let you know... Stock intake plenum is 1.450cc, mine is almost 1.900cc all the welding is done, just need to do a leak test.
A lot tape used to find out the capacity of the plenum...
A lot tape used to find out the capacity of the plenum...
#32
Moderator
Join Date: Mar 2009
Location: wamego, kansas
Posts: 5,280
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2001 hyundai tiburon
impressive work fing02.gif
the only thing I would've changedwas to use a single formed piece of aluminum as a cover piece rather than angle but as long as you get good penetration on your welds you shouldn't have a problem.
the only thing I would've changedwas to use a single formed piece of aluminum as a cover piece rather than angle but as long as you get good penetration on your welds you shouldn't have a problem.
#37
Sweeeeeeet fing02.gif
So, how about performance gains? Did u notice much? I see u have a fuel pressure regulator...have u adjusted it to compensate for the increase in air?
Good job man hail.gif
So, how about performance gains? Did u notice much? I see u have a fuel pressure regulator...have u adjusted it to compensate for the increase in air?
Good job man hail.gif
#40
Senior Member
Thread Starter
Join Date: Jun 2007
Location: Costa Rica
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
<div class='quotetop'>QUOTE (PJAY @ May 21 2008, 05:43 PM) <{POST_SNAPBACK}></div><div class='quotemain'>So, how about performance gains?</div>
Dyno day in a couple of weeks...
Dyno day in a couple of weeks...