Finally Equal Length Tubular Headers! Pics Inside!
10-09-2007, 01:55 PM
#21
Senior Member
Join Date: Mar 2006
Posts: 461
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 1999/Tiburon/RD1
hail.gif hail.gif hail.gif
These look hot!!
To bad I'm in Sweden right now....
Somewhere next year we need to have a chat about sending a beautifull package to the Netherlands once again fing02.gif
These look hot!!
To bad I'm in Sweden right now....
Somewhere next year we need to have a chat about sending a beautifull package to the Netherlands once again fing02.gif
10-09-2007, 03:38 PM
#23
Senior Member
Join Date: Feb 2006
Location: Hereford Az.
Posts: 977
Likes: 0
Received 0 Likes
on
0 Posts
Whoa!! hail.gif
These look great!! I was willing to pay for the Maintec GT headers, but since you did these they look much better. I just hope now that they dont buzz and you will be recieveing a payment from me. fing02.gif
These look great!! I was willing to pay for the Maintec GT headers, but since you did these they look much better. I just hope now that they dont buzz and you will be recieveing a payment from me. fing02.gif
10-09-2007, 04:31 PM
#24
Senior Member
Join Date: Jul 2007
Location: erie pa
Posts: 304
Likes: 0
Received 0 Likes
on
0 Posts
im in for one of them. i have been looking for a good/cheap header and there was no middle ground these look to be it. I just hope they are thick enough they dont buzz at all. looking forward to the audio clip. how much extra toqure are these going to make? and do they really only take 15 min to install thats awesome
10-09-2007, 07:00 PM
#25
http://www.hyundaiaftermarket.org/images/vendor1.png
Thread Starter
Join Date: Dec 2002
Posts: 3,237
Likes: 0
Received 0 Likes
on
0 Posts
No, I'm an idiot and said they'd take 20 minutes. The truth of it is that I know my car well enough to grab every random tool I know I'll need, and get it done. Notice there are no gaurds under the engine in the pics, or most of what everyone else will be removing piece by piece. It took me maybe 25 minutes today. I actually did it without removing the powersteering. I just took out the top two bolts from the power steering bracket, and loosened the third below. With the pump bolt loosened, I just pushed it all the way up, and then pulled the whole bracket towards the passenger fender, it the Header slid right into place. I garuntee even with stock fans this will fit up to the head perfectly. I was worried about the oil pan, but after I tightened the bolts, everything was good and far away from it.
Sound wise... I'm dying right now knowing I cant make a sound clip. What should I do to get one? I have sound and video, and I cant use it!!! I'll figure it out, but at least before I do, I can tell you, that's a mean growl considering its all stock exhaust from a 00-01 Tib. I'll make sure to get the clip now, and then after I have my straight race pipes on so you can hear the diff. wink1.gif
Sound wise... I'm dying right now knowing I cant make a sound clip. What should I do to get one? I have sound and video, and I cant use it!!! I'll figure it out, but at least before I do, I can tell you, that's a mean growl considering its all stock exhaust from a 00-01 Tib. I'll make sure to get the clip now, and then after I have my straight race pipes on so you can hear the diff. wink1.gif
