I tried to reach the screws from the pedals, and I couldnt do it.... what do i have to ? sad.gif

thanks

any DIY...

 

It's been posted several times how to do it.

And it's a PITA no matter how you go at it.

 

ohhhhhhhhhhh.............I think i going to have to take the ecu out, I going to replace that thing.

i couldnt find anything in webtech.. now I going to check out here, i hope i can find something.

wink1.gif

 

It's pain to get at but when you do I suggest mounting it somewhere else. I did but only because I need access to it all the time.

 

you got 2 12mm bolts holding it in there, undo them and it will slide right out

 

ok thanks, but how or from where I can reach that 2 bolts?

i couldnt reach it...

sad.gif

 

I used a gear wrench that had the swivel head to get mine out. It helped a lot considering there's not that much room down there (but it's still a pain anyway you look at it).

 

As has been posted. Take off the fuze box cover on the drivers side. That entire panel.

Then, remove the FUSE BOX, takes like 3 bolts.

Then you have a MUCH better shot at the PITA bolts.

Then bolt it back up with only 3 of the 4 bolts.

 

^^ok thanks, i was searching but I couldnt find anything, but i will do what you are saying .... fing02.gif

thanks

sorry, about this, REDZ did you find out about Western Union?

 

I did ask, but got no answer.

Can you go post in our forums at kspec.rdtiburon.com please?