Yesterday I got my RSide 4-2-1 headers in the mail. Wattsup didn't waste his time getting the bolts, but I could just call Midas and they could order it for me correct?

I have a friend who is going to help do the install. It's still attached the the stock cat so I'll have to get him to help take it off.

Anything else I should know before I install these tomorrow?

 

I would assume they could order them for you, or any shop for that matter...a word of advice, Make sure you have some WD-40 handy wink1.gif

 

might have to remove power streering pump and passenger side fan, just keep that in mind

 

Once again not a hard install just time consuming

 

bolts?

go to a hardware store and buy some ss bolts. they wont rust.

 

Are you referring to bolts at the exhaust flanges or on the head? At the flanges just do what tibby01 said. Since it's a nut/bolt setup there's no specific size it needs to be, just get basically the biggest ones that will fit through the hole.

 

TYou have to remove the Fans to install the header. Bolts u can use SS bolts with lock wasser. I have made this way

 

yeah, i ended up accidently getting the correct thread for the ss bolts when i got them. worked out good since i put just my exhaust on first. fing02.gif

i also had to disconnect my ps pump to get my header in.

 

SS bolts for the flange or the head, tibby01?

I know that there aren't any bolts for the head.

 

flanges. wink1.gif